Index:
<- Pipe Chamber Products

Output Boards (OUTN, OUTP, OUTL, OUTT)

 

Output Boards provides packaged systems with output functionality, a number of Output modules are plugged on the inside of the pin-board face panel.

 

OUTN-1 (Negative Output Board)

This board is available in two versions. The OUTN-1D is used to drive active-low (negative) stop-action magnets. The OUTN-1D/VAR is used to drive pipes. Outputs are capable of sinking up to 350mA (all outputs ON) or 1A (pulse load). They are used to drive stop-action magnets as low as 24 Ohms (12V), or chest magnets as low as 40 Ohms (12V). They have internal spark-suppression diodes. Outputs are fully protected against short-circuited loads and will shut down if overloaded. 

 

OUTN-2A (Negative Output Board)

This board is a new version of the OUTN-1D, and uses surface-mount components. It is used to drive active-low (negative) stop-action magnets. The OUTN-2A/VAR is used to drive pipes. Outputs are capable of sinking up to 350mA (all outputs ON) or 1A (pulse load). They are used to drive stop-action magnets as low as 24 Ohms (12V), or chest magnets as low as 40 Ohms (12V). They have internal spark-suppression diodes. Outputs are fully protected against short-circuited loads and will shut down if overloaded.

 

OUTP-1 (Positive Output Board)

This output board drives up to 48 positive stop-action magnets, chest magnets, lamps, etc. The outputs can source up to 200mA continuously, or 450mA in pulses. The outputs are fully protected against short-circuit loads and will shut down if overloaded. The board is also protected against excessive input voltages and static.

 

OUTL-1 (Output Lamp driver board)

This output board is available in two versions. The first is intended to drive up to 48 external incandescent lamps via series current-limiting resistors. The second is for driving 48 external Light Emitting Diodes (LEDs). Both boards are used in the Classic Organ Works Pipe Control Computer (PCC) and Console Control Computer (CCC). If purchased with a PCC or CCC, it will be fully installed before shipping.

 

OUTT-1 (Output Test Board)

This board plugs onto the output connectors on the face panel (CCIO/OCIO/PCIO). The stop/chest magnet cable then plugs onto it. The OUTT-1 may be used to indicate the status of outputs for diagnostic purposes. Bi-color LEDs on the board indicate the output level: Green means that the output is Low ('ON' for OUTN, 'OFF' for OUTP); Red shows that the output is High ('OFF' for OUTN, 'ON' for OUTP); No colour indicates that the output is open (a possible break in the cable to the magnet).

 

Downloads

OUTL-1 Brochure: View Download

OUTN-1 Brochure: View Download

OUTN-2A Brochure: View | Download

OUTN-2 Brochure: View Download

OUTP-1 Brochure: View Download

OUTP-2C Brochure: View Download

OUTT-1 Brochure: View Download


[Top]

Go to top
Template by JoomlaShine